The NetXpert 1400 provides a complete solution for cable qualification and troubleshooting of active networks, enabling rapid, simple verification and documentation of the capability of cabling links to support Gigabit Ethernet operation compliant with the IEEE 802.3ab standard.
Irrespective of the category of cables and connectors installed, a “Pass/Fail” result indicates whether the existing cabling can support data rates up to 1Gbit/s.
| Measurement Technology | Time Domain Reflectometry (TDR) |
| Cable Measurements
|
Cable Testing and ID: up to 1,000 ft. (305 m) Split Pair Detection: 3 ft. (1 m) to 1,000 ft. (305 m) Length Measurement: 0 to 1,500 ft. (457 m), ± (5%+1ft) Distance to fault: 0 to 200 m ± (5% + 1m) Supports 8 continuity and ID numbers remotes (RJ 45) Supports 20 RJ 45 and 20 F connector ID only remotes |
| Power over Ethernet | Tests for IEEE 802.3af and IEEE 802.3at (PoE +) compliant PoE Tests for classes and loads cable up to 25.5 watts (at class 4 Identifies Mode A or B (pairs with PoE) |
| Active Ethernet | Indicates advertised speeds of 10/100/1000 base-T half or full duplex Can Link to network at 10/100 base-T |
| Maximum Voltage | Parameters refer to the maximum voltage that can be applied to any 2 connector pins without causing damage to the tester – RJ Jack: 66 VDC or 55 VAC – F-connector: 50 VDC or VAC |
| Saved Test Results | Stores up to 250 Cable or network tests with user defined names |
| Tone Generation | Tone Frequencies: 730 Hz and 1440 Hz |
| Languages | English, French, German, Spanish |
| Battery | Li-Ion Akku, 7,2 VDC, 5,500 mA-hr (typical) Battery Life – ca. 32 hrs, 16 hrs with gigabit link, 55 hrs stand-by |
| Temperature | Operating: 32 to 122°F (0 to 50°C) Storage: -22 to 140°F (-30 to 60°) |
| Humidity | 10 to 90% non-condensing |
| Enclosure | High-strength PC/ABS plastic with VO rating with boot Withstands 4 foot (1,20m) drop on to concrete |
| Display | 3,5“ Color Touch Screen Display |
| Size | 6 x 10 x 23 cm |
| Weight | With batteries 508 g |